0 2
A S S E M B L Y (see page 04)
EN
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ The drain valve may only be installed in basins with an
overflow opening.
⁄ The drain valve must only be used as intended. It is not
allowed to attach other objects to the drain valve, for
example a semi-pedestal.
T E C H N I C A L D A T A
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C / 4 min
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
Do not use silicone containing acetic acid!
A D J U S T M E N T (see page 05)
To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow
water heater is not recommended.
D I M E N S I O N S (see page 06)
F L O W D I A G R A M (see page 06)
S P A R E P A R T S (see page 08)
XXX = Colors
140 = Brushed Bronze
350 = Satin Black
360 = Satin Black/Brushed Bronze
600 = Black/Chrome Plated
C L E A N I N G (see page 07)
O P E R A T I O N (see page 06)
Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
F A U L T
C A U S E
R E M E D Y
⁄ Insufficient water
⁄ Jet regulator or service unit dirty/calci-
fied
⁄ Clean/exchange jet regulator or ser-
vice unit
⁄ Mixer dripping
⁄ Cartridge defective
⁄ Exchange cartridge
⁄ Mixer stiff
⁄ Cartridge defective, calcified
⁄ Exchange cartridge
⁄ Instantaneous heater didn’t work
⁄ Flow too low
⁄ Clean/exchange jet regulator or ser-
vice unit
