PLL ALARM CLOCK RADIO WITH WIRELESS QI CHARGER
And USB PORT FOR CHARGING
Model : HX-107CR
INSTRUCTION MANUAL
Note:
Please read and follow these instructions before using your unit.
1.
Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions.
2.
Do not use this apparatus near water.
3.
Clean only with dry cloth.
4.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
5.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce
heat.
6.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
7.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
8.
Only use attachments/accessories specified by the manufacturer.
9.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
10. Unplug this apparatus during lightning storms or when unused for long periods of time.
11. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in
any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
12. Grounding or Polarization – This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider
than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into
the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
13. Alternate Warnings – This product is equipped with a three-wire ground-type plug, a plug having a third (grounding) pin. This plug will
only into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your
electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding-type plug.
14. Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect
it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product
on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless
proper ventilation is provided or the manufacturer’s instructions have been adhered to.
15. The MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
16.
回
: CLASS II apparatus with double insulation, and no protective earth provided.
17. Caution Marking and rating plate was located at bottom enclosure of the apparatus.
18. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
19. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on
apparatus.
20. The mains plug is used as disconnect device. The mains plug of apparatus should not be obstructed OR should be easily accessed
during intended use. To be completely disconnect the power input, the mains plug or apparatus shall be disconnected from the mains.
21. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
22. Excessive sound pressure from earphones and headphone can cause hearing loss.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
1.
Phone Support
15. TUNE/SKIP
+
Button
2.
ON/OFF/AL.RESET Button
16. TUNE/SKIP
−
Button
3.
AUX Button
17. PM Indicator
4.
BT Button
18. AL-1B Button
5.
AL1 Button
19. AL-1M Button
6.
AL2 Button
20. AL-2B Button
7.
FM Button
21. AL-2M Button
8.
MEM/TIME Button
22. USB Charging Port
9.
M
+
Button
23. Wireless Charging Indicator
10. DIMMER Button
24. DC Jack
11. PLAY/PAUSE Button
25. FM Antenna
12. VOL
+
Button
26. AUX-IN Jack
13. VOL
−
Button
27. Battery Compartment
14. SNOOZE/SLEEP Button
CONNECTING THE UNIT TO POWER
AC OPERATION
Plug one end of the AC adaptor into the DC power Input, and then plug the other end into AC wall outlet. Before
switching on the unit, make sure that the voltage of your electricity supply is the same on the rating plate.
BACK-UP BATTERY
The unit has pre-installed a CR-2032 lithium battery inside the back-up battery compartment. In case of power
failure or interrupted AC power, the current time, alarm time and the stored radio stations are preserved in the
memory of the unit by means of battery back-up function.
TURN ON AND TURN OFF THE UNIT
Press the ON/OFF/AL RESET button to turn on or turn off the unit.
SETTING THE CLOCK AND DATE
1. You can only perform the Clock and Date setting when the unit is OFF, press and hold the MEM/TIME button
for about 1 second, the HOUR digit will begin to flash on the display.
2. Press the TUNE/SKIP+ or TUNE/SKIP− button to adjust the hour.
3. When the hour is selected, press the MEM/TIME button again, the MINUTE digit will begin to flash on the
display.
4. Press the TUNE/SKIP+ or TUNE/SKIP− button to adjust the minute.
5. When the minute is selected, press the MEM/TIME button again, the YEAR will show on the display and
flash.
6. Press the TUNE/SKIP+ or TUNE/SKIP− button to adjust the year.
7. When the year is selected, press the MEM/TIME button again, the MONTH and DATE will show on the
display and flash. ( For example : 1 ‘ 15 means 15
th
January )
8. Press the TUNE/SKIP+ button to adjust the month and press the TUNE/SKIP− to adjust the date.
9. When the month and date is selected, press the MEM/TIME button again to confirm and the display will back
to the CLOCK display.
