Manual rotary brush
Locate the rotary brush over the brush
socket and push the brush down until the
brush sits between one and two
millimetres above the disc.. Fix in place
with the rear thumb screw.
Optional mounting socket (rotary brush
extension set)
Already assembled with the ELB and B
devices
.
Do not replace the normal brush with the rotary brush.
The rotayry brush is not required for cleaning all discs.
Select the lowest speed to start the
Mera,Micro and Aragon EL models.
With the ELB models use the “Brush”
button. Loosen the thumbscrew and push
the brush down only so far that is makes
light contact with the disc surface. Relock
the arm with the thumb screw.
The arm is now in the correct position. If
the brush bristles bend and spray cleaning
fluid then you have set the brush too
close to the disc.
.
Wet the disc by hand using the squeeze
bottle supplied with the ELB and B
models. A small wave will form in front
of the brush when you have applie
sufficient cleaning agent.