Instruction Manual
www.hannainst.com
Dear Customer,
Thank you for choosing a Hanna Product.
Please read the instructions carefully before using the
chemical test kit. It will provide you with the necessary
information for a correct use of the kit.
Remove the chemical test kit from the packing material and
examine it carefully to make sure that no damage has
occurred during shipping. If there is any noticeable damage,
notify your Dealer or the nearest Hanna office immediately.
Each kit is supplied with:
• HI 3834-0 Reagent, packets (50 pcs);
• 1 color comparator cube;
• 1 plastic vessel (20 mL).
Note:
Any damaged or defective item must be returned in
its original packing materials.
HI 3834
Iron Test Kit
ISTR3834NR2
07/02
PRINTED
IN
ITALY
Generally, ground and surface water contains no more than
1 mg/L (ppm) iron; but due to mining and industrial
drainage, higher levels of iron have been observed. Iron in
water appears to be more of a nuisance than a hazard.
The presence of iron can stain laundry and give water a
bittersweet taste.
The Hanna Test Kit determines the iron concentration in
water by conversion of the ferrous (Fe
2+
) state. The test is
fast, easy and safe. The color cube makes it simple to obtain
the iron level in water.
Range
0 to 5 mg/L (ppm) Iron
Smallest Increment
1 mg/L (ppm) Iron
Analysis Method
Colorimetric
Sample Size
10 mL
Number of Tests
50 (average)
Case Dimensions
220x145x55 mm (8.7x5.7x2.1")
Shipping Weight
142,5 g (5 oz.)
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
Iron can exist as ferrous (Fe
2+
) or ferric (Fe
3+
) ions. The
Hanna Test Kit determines total iron levels in water via a
colorimetric method. First all ferric ions are reduced by
sodium sulfite to ferrous ions. Phenanthroline complexes with
ferrous ion to form an orange colored solution. The color
intensity of the solution determines the iron concentration.
READ THE ENTIRE INSTRUCTIONS BEFORE USING THE KIT
• Remove the cap from the plastic vessel. Rinse the plastic
vessel with water sample, fill it to 10 mL mark.
• Add 1 packet of reagent
HI 3834-0
.
• Replace the cap and mix solution until solids dissolve.
• Remove the cap and transfer the solution into the color
comparator cube. Let set for 4 minutes.
• Determine which color matches the solution in the cube
and record the result as mg/L (ppm) iron.
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
REFERENCES
REFERENCES
REFERENCES
REFERENCES
REFERENCES
1987 Annual Book of ASTM Standard, Volume 11.01
Water (1), pages 531-535.
Standard Methods for the Examination of Water and Waste-
water, 16
th
Edition, pages 215-219.
The chemicals contained in this test kit may be hazardous if
improperly handled. Read Health and Safety Data Sheets
before performing the test.
