HANGCHA XE Series, Руководство по эксплуатации и обслуживанию

Страница: 63 / 82

59
5.8 Charging steps
1. Park the truck at the charging pile according to
regulations and turn off the key switch, i.e., power
off the truck.
2. Turn off the charger input master switch, make
sure the emergency stop switch is disconnected,
the charger starts automatically, the power
indicator light turns on and the display interface
shows automatically.
Input
master
switch
Emergency
stop switch
Display
interface
3. Press and release the button buckle to take out
the charger. Check the charger to ensure that
there is no water or foreign objects in each port
and that the metal terminals are not damaged or
affected by rust or corrosion.
4. Open the charging ports on the forklift truck
and the charging cover of batteries respectively.
Check the lithium-ion battery charging socket to
ensure that there is no water or foreign objects in
each port and that the metal terminals are not
damaged or affected by rust or corrosion.
5. Connect the charger to the charging socket of
the lithium-ion battery, the charger will check
automatically and communicate with the
lithium-ion battery; when the whole system is
fault-free, after about 15 s, the internal relay of
the charger will be activated and charging will
start, at this time, the charging indicator light will
be on, and the charging voltage, charging current,
charging time and charging fault information will
be displayed on the touch screen.
6. When the lithium-ion battery is fully charged,
the charger will automatically stop charging, and
at this time, the output voltage and output
current on the touch screen is 0. Press the pause
key, and then unlock the charging gun and pull it
out at the same time. If it is necessary to stop
charging the lithium-ion battery when it is not
fully charged, please press the pause key on the
screen first, wait for the charging current to drop
to 0 A and then press and release the button