81
6.3 Operation
Starting and operation
Warning
Never start the truck before any damage
or failure to the truck has been settled.
Starting
−
Open the cover, connect the battery plug,
and then close the cover.
–
Release the emergency stop switch.
Rotate it clockwise for a certain angle, and
the emergency stop switch button will
automatically pop up.
–
Put the direction lever in the neutral
position.
–
Insert the key into the switch lock and turn
it to the right to the "I" stop.
–
The forklift enters a 3-4 second self-check
procedure, and the available battery
power is displayed on the display after the
self-checking is over.
Caution
The forklift will automatically enter the
self-check procedure (about 3 to 4
seconds). The welcome screen will be
displayed on the display screen, and all 6
indicators will be on. The forklift cannot be
driven and lifted during this time. If the
direction switch or accelerator pedal or lift
switch, etc. is operated during this period,
a fault code will appear in the screen and
the fault indicator “ ” will light up.
−
Hold the steering wheel handle firmly with
your left hand and turn on the key switch
with your right hand.
−
Tilt mast backwards
−
Operate the lifting lever to raise the forks
150 to 200mm off the ground. Operate the
tilt lever to tilt the mast all the way back.
−
Operate the direction lever
-
To drive forward: push the direction
lever forward;
-
To reverse: pull the direction lever back.
−
Release the hand brake lever:
−
Depress the brake pedal, push the hand
brake lever all the way forward.
−
Grip the steering wheel knob with your left
hand and slightly rest your right hand on
the steering wheel.
Driving
Slowly depress the accelerator pedal until the
forklift starts to travel forward or backward.
Decelerating
Slowly release the accelerator pedal, the forklift
will slow down.
Caution
Always decelerate in the following
6
5
