75
6 Operating instructions
6.1
During running-in
New forklifts should run under low load in the initial stage
of being put into use. In particular the
following requirements should be met within the first 100 hours of operation:
–
Battery over discharge must be prevented during initial use.
–
Generally, it should be charged in time when it is 80% discharged.
–
Required preventive maintenance must be carried out thoroughly.
–
Avoid sudden braking, acceleration or cornering.
–
Carry out oil changes or lubrication ahead of schedule in accordance with regulations.
–
Limit the load weight to 70%
–80% of the rated load.
6.2 Check and adjust before operation
For the safe operation of the forklift, the forklift must be checked and adjusted accordingly before
operating the forklift.
Warning
⚫
If there is damage or potential risk on forklift or attachment after check, then do not
operate the forklift before repairing.
⚫
In addition to testing lights and checking operating performance, before checking the
electrical system, turn off the key switch and disconnect the battery plug.
⚫
Before operating the vehicle, the operator should be familiar with the unconventional
operating conditions, in which additional safety precautions need to be taken, or
special operating instructions should be followed.
–
Visual check the forklift, pay attention to the wheel, wheel bolt and load part if damage or loose.
–
Visual and hand touch check that the transaxle, hydraulic system, brake system and battery
for leaks or damage.
–
Check the tire pressure: Use an air pressure gauge to check whether the tire pressure is at
the specified value (0.9 MPa for the front wheel / 0.8 MPa for the rear wheel).
–
Check if the battery box is locked.
–
Check whether the driver's seat functions normally, and adjust the seat position according to
the actual situation of the driver.
–
Adjust the front and rear and upper and lower positions of the armrest control device according
to the driver's own situation.
–
Check the correct function of the seat belt: The seat belt must be locked when pulled out
