39
7. Deposit
Deposit daily
Park your truck on a level
ground-preferably in a wide area. If
parking on a slope is unavoidable, position
the truck so that it cross the slope and
block the wheels to prevent accidental roll.
Make sure the shift level on neutral
position.
Pull the hand brake.
Shut down the engine and control the
lift and tilt level several times so that the
inner pressure in the hydraulic tube will
decreased.
Take down the key and deposit it in a
safe position.
Warning!
You should tell the manager if you
find any failure about the truck, then
repair it immediately.
Do the following things:
Clean the oil and grease with cloth and
water on the truck body.
Check the whole situation of truck,
especially the tyres.
Fill the oil tank with destined fuel.
Check whether the hydraulic oil, the
engine oil, fuel and the cooling liquid
are leakage.
Fill lubricate grease.
Check whether the junction plane
between the nuts of wheel boss and the
piston of hydro cylinder is loose, and
whether the surface of piston has been
pulled.
Check whether the wheels of mast roll
stably.
Lift the lifting cylinder to the top and
fill it with oil.
In cold weather, it needn’t to discharge
the antifreeze, but the cold water should
be removed completely.
Deposit the truck for a long time
Deposit the truck for a long time,
fill up the truck body and counter
weight with block to reduce the load of
the two rear wheels.
△
!
Warning!
a
. The block must be single and hard
enough to support the truck.
b
. Don’t use a block with high than
300 mm
（
11.81 inch
）
.
c
. Lift the truck to height of placing on
the bearing block.
d
. Place two same size blocks under the
left and right sides of the truck.
e
. After supporting the truck with block,
swing the truck forward, backward, left
and right, check its safety.
On the basic of the “deposit” you
should do these checks and maintain
additional:
1.Take down the battery and recharge it
once a month, place it in the shade.
2.Brush antirust oil on those parts which is
exposed such as piston rod and axle.
3.Put a cloth on vent-plug and air-cleaner.
