13
3. Safety instructions
1. Only trained and authorized
operator shall be permitted to operate
the truck.
2. Inspect the truck at periodic
intervals for oil or water leak,
deformation, lousiness, etc. If neglected,
the life of the truck will be shortened
and in the worst case a fatal accident
would occur.
Make sure to replace the
“
key safe
parts
”
at periodical inspection.
Wipe off oil, grease or water from
the floor board and foot and hand
controls, if any.
Shut down the engine before
inspecting the engine and its allied
components. Especially use caution to
the engine fan.
When inspecting the radiator or
muffler, exercise caution not to get
burnt.
3. Any time you find that the trucks
are not functioning properly, operation
of the truck should be halted and the
condition reported to the supervisor.
When doing maintenance in the
high place (such as mast, front and rear
lights) should be care of slide and
clamped.
If any warning lamp comes on,
move to a safe place and check or repair
the trouble.
When doing maintenance, take care
of edges and corners to lacerate hands,
head and other parts of body.
The sign of defect should be put on
the defecting forklift truck.
4. Don’t use an open flame to check
level, or for leakage, of fuel, electrolyte
or cooling water.
Never smoke while inspecting the
battery, handling fuel or working on the
fuel system. There is a danger of
explosion.
At working place fire extinguisher
should be prepared.
Never fill the fuel tank with the
engine running.
5. Warm up the temperature of water
to 70
℃
before operation; and cool down
the temperature of water to lower than
70
℃
after work.
If the temperature of the water tank
is higher than 70
℃
, never open the tank
cap.
6. When using your truck in an enclosed
space, make sure there is enough
ventilation. If needed, use a ventilation fan.
Don’t work in a closed working space
because of the tail gas of truck is
dangerous to health.
It’s forbidden to use truck under a
circumstance of flammability and easy
to blast.
7. Never mount or dismount the
moving truck. Use the safety step(s) and
safety grip facing the truck when
mounting or dismounting the truck.
8. Never attempt to work the controls
unless properly seated.
Before staring, adjusting the seat so
you can get easy access to all hands and
foot controls.
9. Before staring, make sure no one is
under, on and close to the truck.
The forward-reverse lever is in
neutral.
10. Park the truck on a level surface
and apply the parking brake securely. If
