H&S 2958, Руководство оператора

Страница: 31 / 54

4.9 Storage
At the end of the season, the machine should be thoroughly inspected and
prepared for storage. Repair or replace any worn or damaged components to
prevent any unnecessary down time at the start of the next season.
Follow this procedure:
1. Wash the entire machine thoroughly using a water hose or pressure washer to
remove all dirt, mud, debris or residue.
2. Inspect all drives and moving parts. Remove any string, twine or other material
that has become entangled in the rotor, flails, cradle components or shafts. Be sure
all components are clean and can move freely.
3. Inspect all hydraulic hoses, fittings, lines, couplers and valves. Tighten
any loose fittings. Replace any hose that is badly cut, nicked or abraded or is
separating from the crimped end of the fitting.
4. Inspect rotor and flails for damaged or broken components. Repair or replace
components as required.
5. Lubricate all grease points. Make sure all grease cavities have been filled with
grease to remove any water residue from the washing.
6. Raise lift arms to their fully up position and install lock pin.
7. Apply "never seize" or grease to PTO input shaft and cylinder rams.
8. Touch up all paint nicks and scratches to prevent rusting.
9. Move the machine to its storage location.
10. Select an area that is dry, level and free of debris.
11. Place planks under the jack for added support if required.
12. Unhook the machine from the tractor (Refer to Section 4.6).
13. Cover the machine with a tarp if the machine is not stored inside.
- 4.14 -