Handicare Raptor, Руководство по обслуживанию, Страница: 85 / 163

E
GIS
SK75326/6
PG
DRIVES TECHNOLOGY
54
7 Production Tests
7.1 Mounting
Make sure that the tiller module is securely mounted. Do not overtighten any securing
screws.
Ensure that the adhesive sealing overlay is fully pressed down.
7.2 Cables and Connections
Check all cables and connections to the tiller module for damage. Ensure there are
no dry solder joints.
7.3 Operational Test
The following tests should be carried out on a level floor with at least one meter of clear
space around the scooter.
With the scooter switched off, displace the throttle and then switch the scooter on.
The TruCharge display should “ripple” up and down. When you have observed that all
the bars illuminate, release the throttle and the display should now become steady
and indicate the battery condition.
There are two conditions when this test cannot be performed. Firstly, if the controller is
programmed (Tiller Displacement on Start-up) to instantly trip if it is powered-up with
the throttle displaced. Secondly, if the controller is programmed (High Pedal Disable)
to drive immediately after power-up regardless of throttle position.
If this test cannot be performed due to the above conditions, then the only other test
method is to power-up the scooter with fully charged batteries and check that all the
TruCharge bars illuminate.