Handicare Raptor, Руководство по обслуживанию, Страница: 42 / 163

PG
DRIVES TECHNOLOGY
11
E
GIS
- O
PERATION
SK75326/6
The information in the following diagrams still applies, so for example, if an Egis with this
feature enabled had a throttle fault, the status lamp would flash 7 times, pause briefly,
flash 7 times, pause briefly and so on.
8.6 Slow or Sluggish Movement
If the scooter does not travel at full speed and the battery condition is good, check
the position of the speed limiting control. If adjusting the speed limiting control does
not remedy the problem then there may be a non-hazardous fault. Contact your
service agent.
The battery needs charging or there is a bad connection to the
battery. Check the connections to the battery. If the connections
are good, try charging the battery.
1 Bar
There is a bad connection to the motor. Check all connections
between the motor and the control system.
2 Bar
The motor has a short circuit to a battery connection.
Contact your service agent.
3 Bar
The freewheel switch or manual brake disengagement
mechanism are operated. This is instigated only on systems
where there is a switch wired to the Egis’ Freewheel input.Check
the position of the switch
4 Bar
Not used.
5 Bar
The controller is being inhibited from driving, this may be
because the battery charger is connected or the seat is not in
the driving position.
6 Bar
A throttle fault is indicated. Make sure that the throttle is in the
rest position before switching on the scooter.
7 Bar
A controller fault is indicated. Make sure that all connections are
secure. Contact your service agent.
8 Bar
There is a bad connection to the parking brake. Some scooters
will register this error type when the freewheel lever is
disengaged. First of all, check the freewheel lever is in the drive
position, then check all connections between the parking brake
and the controller.
9 Bar
An excessive voltage has been applied to the controller. This is
usually caused by a poor battery connection. Check the battery
connections.
10 Bar