Handicare Raptor, Руководство по обслуживанию, Страница: 115 / 163

SP1A
SK73762/6
PG
DRIVES TECHNOLOGY
10
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
The values are approximately displayed in “units” of 100ms and correspond to the
time taken to reach full reverse speed from standstill, i.e. the higher the value the
slower the acceleration.
If there is no Slow/Fast switch fitted then only the Fast
value will be relevant.
4.4 Reverse Decel’n ?
Adjusts the value for reverse deceleration (or braking) of the scooter, in increments of
1. There are two settings:
Fast This value is used when the scooter’s slow/fast switch is set to fast.
Slow This value is used when the scooter’s slow/fast switch is set to
slow.
The values are approximately displayed in “units” of 100ms and correspond to the
time taken to reach standstill from full reverse speed, i.e. the higher the value the
slower the deceleration.
It is the responsibility of the scooter manufacturer to ensure
that the emergency stopping distance is within the distance
specified for the country in which the scooter will be used.
For countries requiring CE marking this is as specified in
EN12184.
Setting this value too high could cause the scooter to tip
when stopping whilst reversing down a slope.
4.5 Max Forward Speed ?
This sets the MAXIMUM forward speed of the scooter. There are two available settings.
Fast This value is used when the slow/fast switch is set to fast.
Slow This value is used when the slow/fast switch is set to slow.
The value is displayed as a percentage of the scooters total available output. Therefore
if the Fast value is set to 80% then the scooter will be able to drive at up to 80% of the
total available speed when the Slow/Fast switch is in the Fast position.
If there is no Slow/Fast switch fitted then only the Fast
value will be relevant.