Handicare Raptor, Руководство по обслуживанию, Страница: 114 / 163

PG
DRIVES TECHNOLOGY
9
SP1A - P
ROGRAMMING
SK73762/6
4 Programming Menu
The menu, contains all the parameters which set the normal drive characteristics of
the vehicle. Each parameter is explained in the following paragraphs.
4.1 Forward Accel’n ?
Adjusts the value for forward acceleration of the vehicle, in increments of 1. There are
two settings:
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
The values are approximately displayed in “units” of 100ms and correspond to the
time taken to reach full forward speed from standstill, i.e. the higher the value the
slower the acceleration.
If there is no Slow/Fast switch fitted then only the Fast
value will be relevant.
Setting this value too high could cause the scooter to tip
when accelerating up a slope.
4.2 Forward Decel’n ?
Adjusts the value for forward deceleration (or braking) of the vehicle, in increments of
1. There are two settings:
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
The values are approximately displayed in “units” of 100ms and correspond to the
time taken to reach standstill from full forward speed, i.e. the higher the value the
slower the deceleration.
It is the responsibility of the scooter manufacturer to ensure
that the emergency stopping distance is within the distance
specified for the country in which the scooter will be used.
For countries requiring CE marking this is as specified in
EN12184.
4.3 Reverse Accel’n ?
Adjusts the value for reverse acceleration of the vehicle, in increments of 1. There are
two settings: