Handicare Raptor, Руководство по обслуживанию, Страница: 129 / 163

SP1A
SK73762/6
PG
DRIVES TECHNOLOGY
24
The battery needs charging or there is a bad connection to the
battery. Check the connections to the battery. If the connections
are good, try charging the battery.
1 Bar
There is a bad connection to the motor. Check all connections
between the motor and the controller.
2 Bar
The motor has a short circuit to a battery connection.
Contact your service agent.
3 Bar
The freewheel switch is activated or the manual brake
disengagement mechanism is operated. Check the position of
the switch or lever. Check the controller voltage. Refer to 3.4.
4 Bar
Not used.
5 Bar
The controller is being inhibited from driving, this may be
because the battery charger is connected or the seat is not in
the driving position. Check the controller voltage. Refer to 3.6.
6 Bar
A throttle trip is indicated. Make sure that the throttle is in the rest
position before switching on the scooter. Check the controller
voltage. Refer to 3.7.
7 Bar
A controller trip is indicated. Make sure that all connections are
secure. Contact your service agent.
8 Bar
There is a bad connection to the parking brake. Check all
connections between the parking brake and the controller.
Check the controller voltage. Refer to 3.9.
9 Bar
An excessive voltage has been applied to the controller. This is
usually caused by a poor battery connection. Check the battery
connections. Check the controller voltage. Refer to 3.10.
10 Bar
3 Trip Types and Their Possible Causes
Once the trip type has been established, refer to the relevant section below for further
information.
The controller has entered sleep mode. Switch the scooter off
and on again.
Blink