Handicare Raptor, Руководство по обслуживанию, Страница: 108 / 163

PG
DRIVES TECHNOLOGY
3
SP1A - P
ROGRAMMING
SK73762/6
1 Introduction
The main advantage of using programmable controllers is that they can be easily
tailored to the specific needs and capabilities of a particular vehicle while taking into
account safe performance characteristics.
The programmable controller achieves this great flexibility by referring to a set of internal
parameters which govern factors such as the vehicle’s speed, acceleration and
braking. These parameters can be changed over a wide span to suit different vehicles
and users, using a simple, hand-held programmer.
If you are using the SP1a programmer with a DT125 controller,
please contact PGDT for more information.
It is possible to set up a controller so that it is unsuitable
for some uses and possibly even some vehicles. Take care
when programming a controller and if you need any advice
in programming or selecting values, please contact PGDT.
Programming should only be conducted by competent
personnel with in-depth knowledge of PGDT electronic
controllers. Incorrect programming could result in an unsafe
set-up of a vehicle for a user. PGDT accept no liability for
losses of any kind if the programming of the controller is
altered from factory pre-set values.
1.1 Use of a SP1a with Solo, Egis, and S-Drive
In general all SP1a Programmers can be used with DT125, Solo, Egis, and S-Drive
controllers. However, depending on the exact version of SP1a you have, then some
functions may not be available.
If you are using the SP1a programmer with a DT125 controller,
please contact PG Drives for more information.
You can identify your SP1a by looking at the type number. This will be either D49371/x,
or D50040/x, where x is the release version of the firmware.
Different versions of the SP1a are fitted with a different connectors. These are:
SP1a (Solo) D49371/x
SP1a (Egis/S-Drive) D50040/x
Adapters are available. For all connection details refer to section 3.1.
Earlier SP1a programmers are not configured to program
the additional parameters in the S-Drive or Egis controllers.