HandHeld Dolphin 7850 Series, Руководство пользователя

Страница: 64 / 132

7 - 2 Rev (b)
5/15/2007
Dolphin® 7850 Series User’s
Guide–Preliminary
Default Com Port Assignments
The Dolphin terminal ships with the com ports assigned as follows:
Installing Additional Software
Dolphin terminals ship with the operating system, radio drivers, and custom Hand Held Products software loaded onto the device.
These are the default programs that install when your terminal first boots up. You can install additional software programs to the
terminal provided that the following parameters are met:
• The software program was created for a Windows Mobile device.
• The terminal has enough memory to store and run the program.
• The program has an *.exe, *.cab, or *.dll extension.
The most popular place to find software on the Windows Mobile website: www.microsoft.com/windowsmobile/products/pocketpc/
When selecting programs, verify that the program and version of the program are designed for the Windows Mobile 5.0 and the
terminal’s processor. You can verify your processor by tapping Start > Settings > System tab > About > Version tab. Make a note
of the information in the Processor field.
To install additional software, you can use the communication options described in this chapter.
See,
• Adding Programs via ActiveSync , page 7-4.
• Adding Programs From the Internet , page 7-7.
• Adding Programs via Infrared , page 7-9.
Com Port Assignment
1 Serial port; this is the 17-pin mechanical connector on the bottom panel.
See
Mechanical Connector on page 3-8.
2 Bluetooth Module
If there is no Bluetooth hardware installed on the terminal, this com port is unassigned.
3 Raw Infrared
4 Unassigned
5 USB virtual serial port
6 IrDA, if IrDA is enabled. If IrDA is disabled, this com port becomes available.
7, 8, & 9 Unassigned
These are virtual com ports that are available for selection only when connecting to devices that
use virtual com ports, such as Bluetooth.
!