AI-002 operation manual
Issue 1 21.09.09 display version 13 . main controller version 69 . servo version 61
P.35 of 59
>
Advance Operation (cont.)
>> Individual Program for Start/ Middle/ End of Tape
AI-002 can recognize the stage of tape sealing, individual programs can be used to change the
behavior of the machines according to whether the stage is in the start, middle or end of sealing.
To invoke the set up pages of these programs, touch the respective area in the seam tape graphic
symbols as illustrated below:
1
2
3
4
1. upper roller symbol
2. fabric symbol
3. seam tape symbol
4. air nozzle symbol
On the individual programming pages, parameters that can be altered are represented by blinking
symbols. Touch these symbols to enter into corresponding data entry mode. Simple explanation
and range of the parameter will be shown up at this time.
Note:
Since the operating software is being upgraded constantly to accommodate new
features, please refer to the on screen menu and Appendix D for further explanation.
