H&B DAD 141.1, Техническое руководство

Страница: 28 / 54

DAD 141.1 Technical Manual, Rev. 2.5 – April 2015 Page 28 of 54
9. Commands
– Overview
Command Short description Parameter value Page
AA Get/set analog output action (base) 0 through 8 48
AD Communication: Device Address 0...255 47
AG Absolute gain calibration ± 32000 34
AH Get/set analog high -999999 to 999999 48
AI’n’ Assign Input ‘n’ to 1 out of 15 different functions/base
0 to 15 43
AL Get/set analog low -999999 to 999999 48
AM Analog Output Mode Current / Voltage 0 to 5 48
A’n’
Action for Setpoint
‘n’: choose 0 of 8 different base for setpoint ‘n’
0 to 8 45
AS
Save analog output parameters none 49
AZ Absolute zero point calibration ± 32000 34
BR Communication: Baud Rate
9600…115200 baud 47
CE Calibration: Open Calibration Sequence; Read TAC Counter 0...65535 31
CG Calibration: Set Calibration Gain (Span) at Load > Zero 1...999999 32
CI
Calibration: Minimum Output Value
–999999...0
31
CL
Communication: Close Device None 47
CM Calibration: Set Maximum Output Value 1...999999 31
CS Save the Calibration Data (CM, CI, DS, DP, etc.) to the EEPROM None 34, 49
CZ Calibration: Set Calibration Zero Point
– Scale Without Load
None 32
DP Calibration: Set Decimal Point Position 0...5 32
DS Calibration: Set Display Step Size
1, 2, 5, 10, …, 500
32
DX Communication: Set full-duplex (1) or half duplex (0) 0 or 1 47
FD Factory default settings: Write Data to the EEPROM (TAC protected) None 33
FM Read / modify filter mode: IIR (0) or FIR (1) 0 or 1 36
FL Digital low pass filter: Filter Cut-off Frequency 0...8 36
GA Output: Get Triggered Average Value None 41, 50
GG Output: Get Gross Value None 40
GH Get Hold Value None 41
GI
Retrieves an image file from the
DAD141.1’s EEPROM
None 49
GN
Output: Get Net Value None 40
GM Get Peak (Maximum) Value None 41
GO Get Peak tp Peak Value None 41
GS Output: Get ADC Sample Value None 40
GT Output: Get Tare Value None 40
GV Get Valley Value None 41
GW
Output: Get Data String “Net/Gros/Status“
None 40
H’n‘
Hysteresis for Setpoint H0 (S0) or H1 (S1) or H2 (S2) -9999...+9999 45
HT Trigger function: Hold time for Violation of Setpoint Limit 0...65535 ms 46
ID Device information: Identify Device None 30
IH Hardware version None 30
IN Logic input: for each Input Status 0 or 1
0000…0011
43
IO Logic output: for each Output Status 0 or 1
0000…0111
44
IS Device information: Identify Device Status None 30
IV Device information: Identify Firmware Version None 30
MT Trigger function: Measuring Time for Averaging 0...3000 ms 50
NA Network Address <aaa.bbb.ccc.ddd> e.g. 192.168.0.100 47
NR Motion detection: No-motion Range 0...65535 d 35
NT Motion detection: No-motion Time Period 0...65535 ms 35