INSTALLATION/ASSEMBLY IN THE VEHICLE
The Kit BL-600 can be easily connected to your existing car radio ISO
wiring loom.
To do this, follow the steps one-by-one as described below:
Before starting, disconnect the main terminal
post (+) of the vehicle's battery.
Removing the radio
Remove your car radio in order to access the ISO loom connections
behind the dashboard.
To do this you may have to use your car radio's removal tools which will
have been supplied as accessories with it.
Refer to the installation manual for your car radio to carry out this
operation correctly.
CONNECTION (vehicle equipped with an ISO connector)
Disconnect the ISO double connector and audio and power cables from
the radio.
Connect the female ISO connectors on the cable provided with your BL-
600 kit to the connectors on your vehicle's ISO loom.
Next connect the male ISO connectors provided with your BL-600 kit to
the ISO connectors on the radio.
MALE
FEMALE
INSTALLING THE MODULE
Fitting the Bluetooth
TM
module
Find a location far from the heating/air
conditioning system or any source of heat. Make
sure this location does not prevent the
Bluetooth
TM
radio signal from being transmitted to the passenger
compartment.
Make sure also that the distance between the loom and the module is
not so great as to prevent it being connected.
Fix the module on a support.
Take the white socket on your BL-600's cable from the dashboard to
where you have fixed the module (pass the cable behind the dashboard
to make the installation unobtrusive).
Connect the 14-pin connector to the module and press home until it
locks.
Fitting the LCD control
The LCD control is provided with double-sided
adhesive.
You can locate it anywhere provided the distance
between the module and the control is not too great as to prevent them
being connected.
Place your LCD control at a reasonable distance making sure
that you can access it without affecting your normal driving position.
Check also that the LCD control does not prevent access to any
controls on the vehicle such as flashers, horn, hazard lights or rear-view
mirror etc. and under no circumstances interrupts your field of view.
Stick the adhesive to the back of the control then peel off the film to fix
the control in the chosen position.
