Hand Held Products SCANTEAM 2070 BASE, Руководство пользователя

Страница: 64 / 132

4–4 Cordless System Manual
Beeper Pitch
You may wish to set your beeper to a higher or lower pitch. This feature is
helpful if there are several scanners being used in close proximity. Different
pitches make it easier to distinguish which scanner is beeping.
Medium High
High
Low
✱
Medium
Decode Beep Selection
Note: Decode Beep mode is active only when the programming selections
Host ACK (page 3–5) or Data Format Required (page 4–16) are turned on.
When Host Ack Selection is on, the scanner will only beep/blink in response to
the Escape commands generated by the host. Should you also want the
scanner to beep when a bar code has been successfully decoded, turn on the
Decode Beep Selection.
When Data Format Required is on, the scanner will only beep if the input data
conforms to the edited format or triple beep if it does not meet the format
requirements. Should you also want the scanner to beep when a bar code has
been successfully read and sent to the host from the base, turn on the Decode
Beep Selection.
On
✱
Off