Hand Held Products IMAGETEAM 5620, Системное руководство, Страница: 137 / 180

IMAGETEAM™ 2020/5620 System Manual 10 - 5
Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren’t sure what programming options are in your scanner, or you’ve
changed some options and want the standard product default settings restored,
scan the
Standard Product Default Settings: Current Application Group bar
code below.
The Menu Commands starting on page 10-6 list the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the scanner and the base to
perform a reset and become unlinked. Refer to "Linking Scanner to
Base" on page 1-6 for additional information.
Note: If your scanner is in multiple scanner mode and you scan either the
current or all application group default bar code, you will hear up to 30
seconds of beeping while all scanners are re-linked from the base and the
settings are defaulted to * settings. The default interface is keyboard
wedge and the default scanner mode is single scanner locked link mode.
Resetting the Standard Product Default Settings: All
Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands starting on page 10-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups