INSTALLATION
Accessories for installation included.
FIG. 2
1. Drill a screw hole with a diameter of 9 mm in the surface
where the product is to be installed.
2. Put the screw in the hole, put on the lock washer and tighten
the nut.
FIG. 3
NOTE:
• Disconnect the negative/chassis earth cable from the
battery before connecting the product, to avoid damage
from short-circuiting during the installation.
• Follow as far as possible the existing cable routing for
installation of new cables.
• Carefully fasten the cable and any excess length with cable
ties, insulating tape or the equivalent.
• Cable grommets through the firewall should be at a safe
distance from moving parts.
ELECTRICAL CONNECTION
1. Fit a switch within convenient reach from the driving
position.
2. Check the voltage of the electrical system (12 or 24 VDC) and
select matching relays (12 or 24 VDC).
3. Put the headlight socket (2) in the cable socket (3).
4. Switch on the switch and check that the light source goes on.
If not, check that the electrical connections are properly done.
