Hamron 011523, Руководство по эксплуатации

Страница: 19 / 19

EN
19
6. When the object has been lifted a little
over the floor, slowly release the lines.
The line catches will then engage and lock
the object in raised position. Check that
the object is suspended well-balanced,
and that the straps are evenly spaced.
7. Now lift up the object to the required
height by pulling both lines at the same
time. The line catches release when
pulling one or both of the lines.
For this reason hold both lines firmly
when adjusting the position.
8. When the object has reached the required
position, release both lines at the same
time to get the line catches to lock.
Finally, always fasten the lines round
the line fastener for extra security.
9. To lower the object, slowly pull the line
inwards to the line wheel. Pull both lines
to release the line catches.
FIG. 11
10. Carefully release both lines at the same
time to lower the object horizontally.
Never attempt to lower the ends of the
object separately. This will cause the other
end to suddenly release and slide off the
strap.
FIG. 12
IMPORTANT:
Always hold both lines firmly when releasing
the line catches. The line catches release both
lines at the same time, even if you only pull
one line.
(pos. C) line wheel and through the hole in
the line wheel holder with catch (pos. D).
FIG. 7
7. Tie another double knot on the free end
of the line.
FIG. 8
MOUNTING OF LINE FITTING
Complete the installation by mounting the line
fastener (pos. F).
• The line fastener should be fastened to a
vertical wall stud or equivalent structural
element of solid wood with the retaining
screws with crossheads (pos. H).
FIG. 9
• The line fastener should be mounted at a
wide angle. Always bind excess length of
line to prevent the line catches releasing.
USE
1. Use the hook hangers (pos. C) for hanging
up bikes – one hook round the handlebars
and the other under the saddle.
2. Use the straps (pos. J) to hang up bulky
objects. Release the catches in the strap
extender (pos. K) connecting hook.
3. Connect the strap (pos. J) coupling with
the strap extender (pos. K) connecting
hook. Replace the connecting hook catch
to secure the connection. If necessary
adjust the length (pos. J) of the strap with
the adjustable strap.
FIG. 10
4. Insert the loops (pos. J + pos. K) under the
object to be hung up. Put the loop in each
strap end in the hook hangers (pos. C).
5. Pull both lines at the same time to lift the
object. Each line controls each end of the
object, in order to trim the position.