6
Installation (continued)
3
Mounting the light fixture
□
Align the mounting holes in the backplate (B)
with the two studs (CC).
□
Insert the two studs (CC) through the backplate
(B), and secure the fixture with the two acorn
nuts (DD).
□
Restore the power at the fuse or circuit
breaker box.
B
C
DD
CC
5
Testing the light fixture
The sensitivity switch adjusts the amount of distance
that is required to activate the unit. To set to a desired
level of sensitivity:
□
Turn on the circuit breaker and the light
switch. The sensor has 1-2 minutes warm up
period before it will detect motion. When first
turned on, wait 1-1.5 minutes.
□
Set the Time switch to the “TEST” position
and the Sensitivity switch to the “M” position.
The lights turn off in about 5 seconds. Keep
in mind a better sensitivity is achieved by
walking across the coverage area, not walking
towards or away from the motion sensor.
□
Set the sensitivity to the “H” position for a
higher level of sensitivity and “L” for a lesser
level of sensitivity. The reach is approximately
a 30 ft. radius from the motion sensor if set to
the “H” position.
Test
Time Switch
PIR Motion
Sensitivity
Switch
2 6
L M H
D to D
4
Caulking
□
Caulk around Back
Plate (B) and mounting
surface with silicone
sealant (not included).
