1
Use and Care Guide
LOW VOLTAGE LED PATH LIGHT
PACKAGE CONTENTS
A – Lamp Body x1 C – Cage x 1 E – Ground Stake (6.693 in.) x1 G - LED Bulb x1
B – Socket x1 D – Glass Shade x1 F – Wire Connector x1 (with 12 in.wire attached to lamp body)
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING:
Never push the fixture into the ground by the lamp
body (A) or use a hammer to insert the ground stake (E) into the
ground.
□
Insert the fixture wire on the wire connector (F) into the groove
located on the top of the ground stake (E).
□
Ensure the fixture wire on the wire connector (F) stays in the center
of the groove of the ground stake (E) to avoid damage to the fixture
wire. Screw the lamp body (A) onto the ground stake (E).
□
To install the LED bulb (E), insert the base (2) of the LED bulb (E) into
the socket (B).
□
Place the glass shade (D) over the socket (B), and use a phillips
screwdriver to tighten the screws to ensure that the cage (C) and
glass shade (D)are locked on the lamp body (A).
□
Prepare a hole in the installation location. Use a tool such as a
screwdriver (sold separately) to prepare the installation hole to
ensure that the hole is not larger than the ground stake (E).
□
Install the fixture in the ground by pushing on the foot step (1) on
the ground stake (E). Do not push on the lamp body (A).
WARNING:
The wire connector (F) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□
The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (F) on opposite sides of the low voltage
cable (sold separately) from the transformer (sold separately)
where the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of the
wire connector (F).
□
Press the wire connector (F) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□
Once the wire connector (F) is in place, wrap it with electrical tape
(sold separately).
□
After all fixtures are installed, turn on the transformer.
Item # 1008 521 313
Model #
LBW1501AX-01
