Item #1002 753 096
Model #HD33688
Use and Care Guide
LOW VOLTAGE PATHLIGHT KIT
Part
Description
Quantity
A
Pathlight head
1
B
Pathlight lens
1
C
Pathlight post
1
D
Pathlight connector
1
E
Pathlight spike
1
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the pathlight
WARNING:
Never push the fixture into the ground by the fixture’s head (A) or use a
hammer to insert the spike (E) into the ground.
CAUTION: Safe for outdoor operation.
□
Carefully remove the fixture from its protective packaging.
□
Attach the lens (B) to the post (C) and insert the spike (E) into the
post (C).
□
Attach the cap (A) by screwing it on top of the lens (B)
WARNING: Install in accordance with all local codes and ordinances.
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
PATHLIGHT ETL LISTED UNDER MODEL # U000-1923
Please read and save these instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
2
Connecting the wires
WARNING: The wire connector (D) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall be 12-18 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light fitting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6 in. (15.24 cm).
• Do not submerge the fixture in water.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
WARNING: Do not operate the luminaire fitting with a missing or damaged lens
or bulb protector.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
A
B
C
E
D
A
B
C
E
□
Place the wire connector (D) on opposite sides of the low
voltage cable (not included) where the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of
wire connector (D) as shown.
□
Press the wire connector (D) together until fully seated and
locked around the cable. Pre-set prongs will pierce the cable
insulation and establish contact. Turn on the power unit (not
included). If the light fixture does not turn on, repeat previous
steps.
□
Once the clip-on connector (D) is in place, wrap it with
electrical tape for additional protection.
D
CAUTION: BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
