Your BenjiLock
By Hampton™ arrives partially charged.
To ensure the best experience, we recommend that you charge your BenjiLock By
Hampton™ fully before you begin programming.
Charge your BenjiLock
By Hampton™
1.
Remove included USB cable from package.
2.
Connect the USB cable to the lock (bottom) and to a standard USB input.
3.
Note the RED LED on the top of your lock.
4.
RED LED will turn off when the unit is fully charged.
Note: A fully depleted battery will take roughly 3 hours to charge.
Program your BenjiLock
By Hampton™
(Master User)
Programming note: The first user added will be the owner of the lock and will be needed
to add/remove additional users.
1.
Wake up the lock: Touch the fingerprint sensor and BLUE LEDS will illuminate
around the fingerprint sensor.
2.
Insert the key and turn counterclockwise until the BLUE LED fingerprint sensor
light appears solid.
3.
Press any finger against touch screen until BLUE LED fingerprint sensor light
flashes.
4.
Press the silver button at the bottom of the lock one time.
5.
Wait two seconds until the LED light flashes BLUE at the top of the lock.
6.
The LED at the top of the lock will flash once for user 1.
7.
Place your finger on the fingerprint sensor until the BLUE LED at the top of the
lock turns on and remove your finger after it turns off.
8.
Repeat the previous step four more times with the same finger for a total of 5
times. On the fifth time, remove your finger once the BLUE LED light appears
solid. The light will then blink multiple times indicating successful programming.
9.
Remove the key, and your lock is programmed for one of its users.
Troubleshooting: If the LED at the top of the lock flashes RED, this means your
fingerprint has not been recorded. If this happens, simply continue following the steps
for programming.
Add additional users to your BenjiLock
By Hampton™
1.
Wake up the lock: Touch the fingerprint sensor with a finger that is not
programmed and the BLUE LED fingerprint sensor light will flash.
2.
Insert the key and turn counterclockwise until the BLUE LED fingerprint sensor
light appears solid.
3.
Authenticate permission to add users by placing the first finger programmed
(Master User) on the fingerprint sensor until the LED light on top of the lock
turns blue.
4.
You now press the silver button at the bottom of the lock 2-10 times to
correspond to the user you are programming.
Note: Pressing the silver button 2 times corresponds to user 2, 3 times
corresponds to user 3, etc.
