1
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
LED LOW VOLTAGE PATH LIGHT
Use and Care Guide
NOTE
: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
Attaching and installing the
light
□
Attach the fixture head (A) to the post (B) by inserting
the fixture head (A) into the upper end of the post (B)
and then twisting clockwise.
□
Insert the fixture wire (2) into the groove located on
the top of the ground stake (C).
□
Attach the post (B) to the stake (C) by placing the
bottom of the post (B) onto the top of the stake (C)
and twisting clockwise.
□
Prepare a hole in the installation location. Use a
screwdriver to prepare the installation hole to ensure
that the hole is not larger than the stake (C).
□
Install the fixture in the ground by pushing on the foot
step (1) on the stake (C). Do not push on the fixture
head (A).
1
WARNING:
Do not install the light within 10 ft.
(3 m) of a pool, spa, or fountain.
A
B
D
2
1
C
D
Assembly and Installation
Item #1001 513 111
Model #29156
Connecting the wires
2
IMPORTANT
:
• Protect the wiring by routing it in close proximity to the light, fitting,
or next to a building structure such as a house or a deck.
• Do not bury the wiring by more than 6 in. (15.24 cm) in order to
connect to the main secondary wire.
• Do not submerge fixtures in water.
CAUTION:
The wire from the low voltage power unit shall be 12-16 AWG
type underground Low Energy Circuit Cable.
□
Detach and place the wire connector (D) on opposite sides of the low voltage cable (not
included) from the transformer (not included) where the fixture will be located.
□
Align and fit the main low voltage cable vertically in the slot of the wire connector as shown.
□
Press the wire connector (D) together until fully seated and locked around the cable. Pre-set
prongs will pierce the cable insulation and establish contact. Turn on the power unit. If the
light fixture does not turn on, repeat operations 2 and 3.
□
Once the clip-on connector is in place, we recommend to wrap it with electrical tape (not
included) for additional protection.
WARNING:
The connector contacts (D) have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
PACKAGE CONTENTS
A - Fixture head x
12
B - Post x
12
C - Stake with foot step x
12
D - Connector with 12 in. wire length (attached to fixture) x
12
A
B
C
D
