8
Installation (continued)
12
Mounting the door alert
Use either the small screws (BB) or double-sided
tape (FF) to mount the door alert (D):
□
To mount with the small screws (BB), remove
the back of the door alert (D) by pushing in the
tab on the bottom with a small screwdriver.
□
Place the motion sensor back against the
mounting surface and mark the two screw
holes.
□
Drill two 1/16 in. pilot holes.
□
Attach the motion sensor back with the small
screws (BB). Tighten securely and snap on the
front of the door alert (D).
□
When attaching the door alert (D) with double-
sided tape (FF), remove paper from both sides
of the double-sided tape (FF) and apply to a
clean surface.
13
Mounting the magnet
Use the small screws (BB) (or the large screws (CC) if
using the magnet spacer (F)) to mount the magnet (E).
□
Remove the back of the magnet (E) by pushing
in the tab on the bottom of the magnet (E) with
a small screwdriver.
□
Place the magnet back against the mounting
surface and mark the two screw holes.
□
Drill two 1/16 in. pilot holes.
□
Attach the magnet (E) back with the small
screws (BB). Tighten securely and snap on the
front of the magnet (E).
Operation
1
Adjusting the doorbell volume
The doorbell (A) has an adjustable volume control
located on the side. Rotate the thumbwheel up or
down to adjust the volume.
BB
D
CC
F
A
