Hammer K2 M, Перевод оригинальной инструкции по эксплуатации

Страница: 41 / 56

41
K2 M - Part 2/2 Maintenance
4. Press the green [Start] -button on the control panel.
🡆
The machine will not switch on (insert board removed).
5. The saw blade only operates if the limit switch inside the machine frame has
not been actuated (insert board must be inserted).
3.4.7 Lubricating the circular saw height spindle and tilting spindle
1
2
3
Fig. 33: Lubricate adjustment spindle
1 Tilting spindle
2 Height spindle
3 Bevel gearbox (angle adjustment)
Tool:
●
Grease gun
Material:
● Machine Grease
1.
Switch off the machine and secure it against being switched on again.
2. Disconnect the machine from the mains power supply.
3. Remove the rear cover plate.
⮫
Chapter 3.2 ‘Preparations for maintenance
work / Removing the cover plate’ on page 35
4. Lubricating the height spindle:
Position the saw aggregate in the uppermost position.
Lubricate height spindle with normal machine grease.
5.
Lubricating the tilting spindle:
Tilt the saw aggregate in the 90° position (cutting angle 0°).
Lubricate the swivel spindle with normal machine grease.
6. Lubricating the bevel gearbox:
Insert the flexible hose of a grease gun into the gearbox housing.
Lubricate the gearbox with a press stroke.