Hammer A3-26, Руководство пользователя

Страница: 46 / 72

46

!
"
#
Planer-Thicknesser
A3-26 / A3-31 / A3-41
9.4.6 Jointing
Note: To obtain exact joints, use only evenly grown wood without any knots.
1. Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2. Both planer tables must be shut and fixed with the
clamping levers.
3. Set the gear lever to the “0” setting.
4. Extraction system must be connected
5. Planer fence: set at 90°.
6. Adjusting the depth of cut.
7. Adjust the joint, if necessary.
8. Adjust the bridge guard
• Loosen the clamping screw.
• Pull out the guard rail.
(somewhat more than the width of the workpiece).
• Place the workpiece against the planer fence and
push it to the front edge of the feeder planer table
(not over the cutterblock).
• Bring the guard rail right up to the workpiece
• Tighten the clamping screw.
• Use the setscrew to lower the guard rail to the planer
table.
9. Switch the machine on
10. Take up work position.
11. Machining the workpiece:
• With your left hand (balled into a fist and the thumbs
placed onto the workpiece), press the workpiece
against the combination fence and the receiver-side
of the planer table.
• With your right hand (balled into a fist and the
thumbs placed onto the workpiece), push the workpi-
ece smoothly over the cutterblock
• The pushing stick should not be thicker than the work-
piece.
12. If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally
Fig. 9-10: Bridge guard
Attention! Risk of injury!
When jointing smaller workpieces, use a pushing stick or pushing block.
Fig. 9-12: Wooden push stick and push block
Fig. 9-11: Guiding a workpiece
!
Setscrew
"
Clamping screw
#
Protective rail
Operation