Remove
www.hamiltontechnology.com
Tel: (800) 447-9797
Fax: (310) 217-8821
INSTALLATION INSTRUCTIONS FOR 250W & 400W CAYMAN SUN SYSTEM
IF YOU HAVE QUESTIONS, PLEASE CALL US AT 800-447-9797 FOR MORE HELP.
4.
1. Unpack the system.
2. Carefully remove the packaging material from the fixture.
3. Verify that your order was shipped complete
(reflector, LED transformer, hanging wires)
4. With a Phillips screwdriver, remove the 2 screws attached to the angle lens holder.
5. Slide glass lens out of the fixture.
6. Follow the procedures below for proper installation of the Metal Halide bulb.
Do not screw the lens bracket holder until the system is pre-tested.
7. The ballast and bulb wattage must be equal.
8. Connect the ballast quick disconnect with the system lamp cord.
9. Connect ballast power cord to 3 prong grounded (GFCI) outlet
(We recommend using the 5 outlet shock buster GFCI) and grounded timers, only.
10. If unit is working properly turn off the ballast and unplug the unit.
If unit is hot let it cool down for a few minutes before installing it.
11. Screw the lens holder back into the reflector using a Phillips screw driver
12. Follow the hanging instructions.
READ before touching bulb!
IMPORTANT WARNING:
1.
DO NOT touch bulb with bare hand.
2.
DO NOT operate bulb without fixture’s glass in place.
Installing the Lamp:
The lamp should be used only in fixtures designed for it. The fixture must be equipped with a protective
cover glass. Any finger prints should be wiped off lamp with a soft clean cloth dabbed slightly with alcohol.
Install the bulb with protective gloves or a soft cloth.
Push both bulb ends into socket simultaneously
with equal force
.
Both ends should go into socket at the same time.
Do not ignite the lamp if it is broken.
The warranty does not apply to broken ceramic ends. Proper care and placement must be taken to
ensure that the ceramic tips do not break.
14902 South Figueroa Street
Gardena, California 90248
USA
