Hamilton Beach Commercial SmartServe BIC2000, Руководство по эксплуатации

Страница: 6 / 28

6
SmartServe™ must be sanitized before daily use.
1. Wash SmartServe™ following instructions in
“General Cleaning” on page 8.
2. Sanitize using 1 Tablespoon (15 ml) of
bleach per 1 gallon (3.8 liter) of clean, cool
water (60°F [16°C]), mixed according to
the instructions on the bleach. (If using a
sanitizing solution other than bleach, test the
concentration using commercial test strips.
Concentration levels should be between 100
and 200 parts per million of bleach to water.)
3. Turn ON (I) by pressing the Power Switch
under the Control Panel on the right side.
4. Insert cup filled with sanitizing solution.
Close Door.
For MIC only:
• Remove thumbscrews.
5. Run any preprogrammed cycle (using the 1–3
and A–C buttons). DO NOT OPEN DOOR!
For MIC only:
• At end of cycle when Cup Shield moves
upward, slide the Door Assembly toward
you slightly to pause the cycle.
• Use Sanitizing Syringe to inject 60 ml of
sanitizing solution into the Sanitizing Port.
Remove Sanitizing Syringe and set aside.
• Wait 2 minutes or appropriate sanitizing
time.
• Replace Door Assembly and thumbscrews.
Cycle will now finish and return Cup Shield
to the highest position.
6. After appropriate sanitizer time, remove cup
and pour contents down the drain.
7. Allow the equipment to rinse.
For MIC only:
• Press the RINSE button.
NOTE: If this is done at end of day, turn OFF ( )
and remove Door Assembly to allow parts to
dry fully.
1. Place cup in Cup Holder, close Door, and
press START button.
2. Splash Shield lowers and SmartServe™ begins
to blend drink.
3. If a different setting is desired, open Control
Panel Cover if needed and press the choices
using the 1–3 and A–C buttons. Display will
show the buttons that are lit.
4. Press START. Display shows “BLENDING . . .”
NOTE: In some models starting with “BIC,” a
second START button is found on the bottom
front of the machine. Pressing this button also
starts the blending process.
NOTE: Text on screens may vary depending on
model number.
5. When cycle ends, the Splash Shield raises
back up and the Display shows “BLEND
COMPLETE – PLEASE RINSE.” DO NOT
OPEN DOOR UNTIL THE SPLASH SHIELD
HAS RETURNED TO THE HOME POSITION.
6. Remove cup. Close the Door. The Splash
Shield will lower into Wash Chamber. Rinsing
cycle runs for a predetermined time period
and Splash Shield raises. Display will show
“RINSE COMPLETE.” DO NOT OPEN DOOR
UNTIL THE SHIELD HAS RETURNED TO THE
HOME POSITION.
Before Use
Blending or Mixing Instructions
Sanitizing SmartServe™