HAMAR LASER L-708, Руководство по эксплуатации

Страница: 25 / 33

22
Setting the Target Network ID and System ID
To make the unit visible to all other radio-enabled devices, you must set the Target Network ID and the
System ID for the readout.
3. Set the Local Target Network ID
Press the MENU button until the upper display shows
 
with the current Target ID (

)
blinking. Use the UP and DOWN arrow keys to set the Target ID (the default is 01).
Press the MENU button again until the lower display shows
 
with the current Target ID (

)
blinking. Use the UP and DOWN arrow keys to set the Target ID to the same value as that of the
upper display’s Target ID (the default is 01).
The upper display will show the vertical (Y) axis position of the local target.
The lower display will show the Horizontal (X) axis position of the local target.
4. Set the System ID (Radio Channel)
Press the MENU button until the upper display shows
 
, with the current System ID (

)
blinking. Use the UP and DOWN arrow keys to set the System ID (the default is 01).
Connecting to the R-358 Computer Interface
Before using the R-358 Computer Interface, ensure that the battery is fully charged or that the AC
charger/adapter is plugged in. Make all connections with computer power
off
.
1. Connect the target(s) to the INPUT connector on the front of the R-358 Interface.
The interface can support one 4-axis target. It can also support two 2-axis targets with the use of an
optional splitter cable.
2. Connect the R-358 Interface to the computer.
Connect the interface to the computer serial port using the standard RS-232 cable provided. The
connector for the cable is located on the back of the unit and is labeled COMPUTER.
3. Power on the computer.