ORCA-Lightning Digital CMOS Camera C14120-20P Instruction manual_Ver.2.5
43
11-3 CONNECTIONS
Connect the cooling water hoses to the connectors of the circulating water cooler.
Figure 11-1
•
When cables are connected, turn off the power supply of the camera and peripheral devices.
[Connection of water cooling hoses]
1. Place the camera on the stable table.
2. Connect water cooling hose into the WATER
connector on the camera. (as shown in
Figure 11-2) Confirm the hose stops at it.
3. Set the camera onto a microscope
(If the camera is used on the microscope).
If it is easy to connect the hose onto the
camera after the camera is set onto the
microscope then it is OK to connect the hose
after the camera is set on the microscope.
4. Connect the hose onto the circulating water cooler.
Figure 11-2
Follow the instruction on the circulating water cooler when you connect the hose onto the
circulating water cooler.
5. Turn on the circulating water cooler and confirm the cooling water is flowing normally.
•
Stop the circulating water cooler when the water flow is abnormal or water
drop or splash is found.
Camera (Rear panel)
Cooling water hoses (2 hoses)
Circulating
water cooler
Computer
CoaXPress
interface cables (4 cables)
Water cooling hose
WATER connector
