97003C (Rev. B - 5/01)
4540-FTN
MODEL 4540 FOUNTAIN
Halsey Taylor Owners Manual
INSTALLATION INSTRUCTIONS
1. This fountain is to be mounted on a smooth, flat, finished wall surface, with adequate support structure.
2. Establish rim height fountain is to be mounted at.
3. Refer to rough-in for plumbing.
4. Locate and install trap (not included).
5. Install shut-off valve (not included) on building water supply.
6. Secure fountain using 1/4" (6mm) lag screws or bolts (not included).
CAUTION:
This fountain is rated for inlet water pressure of 20-90 psi. Should the inlet water supply
exceed 90 psi, a pressure reducing regulator should be used.
7. Connect fountain to building supply line by running a water line between the shut-off valve and fountain.
8. Turn on water supply and check all connections for leaks.
9. Adjust bubbler stream height. (See instructions below)
TROUBLE SHOOTING & MAINTENANCE
PROJECTOR:
If mineral deposits build up in the orifice, they can be
removed by using a round file or small diameter wire.
CAUTION:
Care must be taken not to damage orifice assembly.
STREAM REGULATOR:
Stream height is factory set at 45-50 psi.
If supply pressure varies greatly from this, remove the
cap from the bubbler assembly/valve regulator and
adjust the screw on the regulator. Clockwise adjustment
will raise stream height and counterclockwise will lower
stream height. A stream height of 1-1/2" (38mm) is
recommended. (See Fig. 1)
FIG. 1
All manuals and user guides at all-guides.com
