Dynamic Virtual Matrix™
© Copyright 2016 Hall Research, Inc.
9
Step 2:
Use an Ethernet Cable to connect the PC (or laptop) and the extender.
Make sure that the power LED (Red) for the extender and the network link
status LED (Green) is blinking.
Step 3:
Open a browser and enter the default IP address of 192.168.1.xx (xx=11
for TX or 12 for RX). You can now change the IP to be Static and change the
address as you like.
Step 4:
Click “Update Settings” in the Network Settings.
Step 5:
Click “Reboot” in the Upgrade Section.
4.0 Configuration & Operation
4.1 Sender’s Front Panel
Figure 4.1 - Transmitter’s Front Panel
HDMI IN:
Connect to the HDMI source such as a DVD or Blu-ray player.
HDMI OUT:
This is a local HDMI loop out for monitoring
IR OUT:
Connect to the supplied IR emitter cable. The IR emitter jack supports
Hall Research’s CIR-EMT and CIR-EMT2 cables.
1000BT:
Connect to a gigabit network router/switch or a Receiver using
CAT5e/6 cable. The green LINK LED illuminates to represent the link from
Receiver has established.
5V DC:
Plug the supplied 5V DC power supply to the unit and connect the
adaptor to an AC outlet and the LED will illuminate.
4.2 Sender’s Rear Panel
Figure 4.2 - Transmitter’s Rear Panel
RS232:
Connect to a PC or Laptop with a straight thru DB9 male to female cable
for serial communication.