Dynamic Virtual Matrix™
© Copyright 2016 Hall Research, Inc.
11
4.3 Receiver’s Front and Rear Panels
Figure 4.4 - Receiver’s Front Panel
Figure 4.5. Receiver’s Rear Panel
The functions of the connectors on the Receiver are similar to those of the
Sender described in the previous section.
5.0 OSD Menu
Figure 5.1 - OSD
Once the installation is completed, the following On Screen Display (OSD) is
displayed on the screen. The OSD behavior can be controlled using Hall
Research’s Dynamic Virtual Matrix Tool™
Windows
Software
or Telnet
command. The user can conveniently select Auto, ON, OFF options. Auto allows
the OSD to be displayed for 10 seconds, while the user can select the ON and
OFF feature to enable or disable the OSD.
F/W Ver:
The firmware version.
RX IP:
This receiver’s IP address.
TX IP:
The connected transmitter’s IP address. Note that the transmitter and
the receiver must be in the same group else 0.0.0.0 will be displayed.
GROUP ID: This receiver’s group number.
DEVICE ID:
This receiver’s device name (user assignable).
STATUS:
Shows the link status. If no transmitter is found in the receiver’s
group “Waiting for connection...” will be displayed.
If the TX and RX are in the same group, but no HDMI source connected to the TX,
then the message “Stream Not Found!” will be displayed.