CAT FLAP
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS
CAREFULLY AND KEEP FOR FUTURE REFERENCE.
Product Codes
#1160, #1161
Parts List
A. Outer door frame
B. Inner door frame
C. 8x Screws
D. 8x Screw covers
E. 4x Adhesive strips
Tools Required
• Jigsaw
• Hacksaw
• Drill and 10mm & 3mm drill bit
• Phillips screwdriver
• Pencil
• Scissors
• Tape measure/ruler
Installation
X
X
1. Measure the height (x) from the
underside of the cats stomach to the floor.
3. Cut out supplied template, line up
height (x) with opening & trace onto door.
4. Drill holes in each of the inside corners
with a minimum of 10mm (3/8”) drill bit.
5. Using a reciprocating jigsaw, cut along
marked lines.
6. Check outer frame fits opening and
screw hole align. Drill 3mm pilot holes.
7. Place outer frame in hole, if the tunnel
protrudes through the door mark around
tunnel.
9. Screw into door from both sides.
WARNING: Over tightening of screws will
cause damage to cat flap.
Please note, screws provided are for maximum surface thickness. If your installation requires a shorter tunnel shorter screws may be
required. For materials other then timber please use suitable fittings. Check before installation.
2. Mark height (x) on door / panel with
tape or similar.
8. Cut along line using a hacksaw.
A
B
C
E
D
X
