HAKO Scrubmaster B115 R, Руководство по эксплуатации

Страница: 19 / 70

19
Operation
2.3 Cleaning operation
Read and follow the safety in-
formation in Chapter 1 before
operating the vehicle.
1. Check the parking space for signs of
leaks. Hoses, lines and tanks must
show no signs of leaks or damage.
2. Check the battery charge, refer to
Section 2.3.1.
The current charge status ap-
pears in the indicator field.
Charge the battery, if neces-
sary, refer to Section 2.3.2.
3. Drain off the waste water tank, refer
to Section 2.3.3.
You are informed the waste
water tank is full via the indica-
tor field.
4. Fill the clean water tank, refer to Sec-
tion 2.3.4.
The maximum temperature is
50°C.
5. Adjust the driver's seat, refer to Sec-
tion 2.3.5.
6. Lock the side deflector.
7. Switch on the vehicle with the key
switch and set the required driving
direction using the driving direction
selection switch, refer to Section
2.3.6.
The operating hour counter
displays the software version,
the last service code (if appli-
cable) and operating hours in
succession. Service code 
table, refer to Section 2.4
8. Press the button for the brush head
and squeegee.
The vehicle is ready for opera-
tion.
9. Press the button for the clean water
supply.
The clean water supply is acti-
vated.
10.Press the button for the clean water
dosing.
The clean water quantity is set.
11.If necessary, press the button for
brush pressure adjustment.
The brush pressure is activat-
ed.
Start driving immediately after
switching on the brush head
drive otherwise imprints of the
brush could be produced on
the floor!
Always raise the brush head
before driving over thresholds!