HAKO 474, Инструкция по эксплуатации

Страница: 5 / 32

4
5. Operation
Spring Iron Holder
(No.B1094)
Cleaning Pin Holder
(No.B1095)
Tube(red)
Cleaning Sponge
Securely insert the
cleaning pin holder.
Iron Holder Base
Preparation-Assembly and Connection
Assemble the HAKKO 474 on a flat surface.
1. Remove the pump securing
screw (M4
×
25 marked red)
from the bottom of the station.
2. Assemble the iron holder.
• Set the spring iron holder and
cleaning pin holder in the iron
holder base.
• Dampen the cleaning sponge with
water and then squeeze it dry.
CAUTION
The sponge is compressed.
It will swell when moistened with water.
Be sure to dampen the sponge with
water before use.
Be sure to remove the round portion of
the sponge.
3. Insert the desoldering gun
and cleaning pins.
• Fully insert the desoldering gun into
the spring iron holder.
CAUTION
The spring iron holder becomes
extremely hot during operation of the
desoldering gun. Do not touch the
spring iron holder during and immedi-
ately after using the gun.
4. Connections
CAUTION
Be sure to turn off the power switch
before connecting or disconnecting
the cord assembly and the power plug.
Failure to do so may damage the P.W.B.
• Connect the cord assembly to the
receptacle (marked “IRON”).
• Connect the hose to the vacuum
outlet cap (marked “VACUUM”).
Insert the cord as-
sembly by keying the
plug to the key on
the receptacle.
Secure the plug by
turning it clockwise.
Fully insert the hose
into the vacuum out-
let cap.
English