Hakko Electronics Monitouch V7, Технические характеристики, Страница: 105 / 128

6-22 2. Main Menu Screen
2-4. Messages during Data Transfer
If an error occurs during data transfer, the message
window shown on the right is displayed.
The kinds and the contents of the messages are shown below. The same messages are used for the
memory card and CF card. When using the CF card, the “memory card” in the explanation should
read as the “CF card”.
OK
Data discrepant
Messages Contents
Work normally finished. The specified operation has been concluded normally.
CREC not connecting No card recorder is connected when selecting a modular jack.
CREC Communication Error A communication error occurred between V7 and CREC when selecting a modular jack.
Memory-Card not setting Memory-Card not setting
Memory-Card Capacity over
Cannot write the data into a memory card because the data size in V7 is larger than the
capacity of a memory card.
Write Protect: ON
Cannot write data into a memory card because the write protect switch in a memory card is
ON.
Writing Error occurred. The error occurred while writing data into a memory card.
Selected data does not exist. The data in the reading target does not exist.
V7 type is different. The specified type of the data in V7 is different from the type of the memory card data.
Selected data can not be read. The data in a memory card cannot be read.
Reading Error occurred. The error occurred during writing data into a flash ROM of V7.
Data discrepant There is some discrepancy in data, when comparing data between a memory card and V7.
Screen data on V7 will be broken.
Warning about data destruction in V7 that may occur when transferring the font data larger
than the present data from a memory card to V7.
(The [OK] switch continues transferring; the [Cancel] switch stops transferring.)
Undefined Error occurred. The error occurred due to some cause other than mentioned above.