Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 425 / 746

Chapter 13 Macro
13-42
Macro Mode
Macro mode can be set for screens and multi-overlaps. The macro mode is a
function that activates the ON macro or OFF macro when the corresponding bit
of the PLC memory changes from 0
→
1 (leading edge) or from 1
→
0 (falling
edge), respectively. However, when the screen (multi-overlap) is opened, they
are executed in the level state. (
Refer to [Execute OFF Macro at Start]
(page 13-43).) A maximum of 32 each of ON/OFF macros can be set using the
consecutive bits.
Setting Items
•
[Part]
→
[Macro]
→
Macro mode setting
Macro Mode Setting
[Division No.]
Specify the division number. Set a division number not registered in another
mode. (
For information on the division number, refer to Chapter 2 in
the Reference Manual (Operation).)
[Memory]
Set the memory that triggers the macro command.
[Number of Relays] (1 to 32)
Specify the number of bits that trigger the macro command. The relay
number specified here is common to both the ON macro and OFF macro.
Example: [Number of Relays: 10] allows a maximum of 10 ON macros and
10 OFF macros. In this case, 10 bits must be allocated for
[Memory].