Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 399 / 746

Chapter 13 Macro
13-16
Printer
The following macro commands are used to send the command for the printer
connected to the V series.
•
MR_OUT/MR_REG
This command can be used when Sato’s barcode printer MR-400 is
connected. For information on how to use this command, refer to “Chapter
15 Print.”
•
OUT_PR
Data in F1 bytes are sent from the F0 memory to the printer.
Available Devices
OUT_PR: Command output to printer OUT_PR F0 F1
Internal
Memory
PLC
Memory
Constant
Memory
Card
Indirect W Word
F0
F1
Example: Paper feed and auto cut are performed on the CBM (293)
printer.
CBM manual: Command table
Print and pitch paper feed: 1BH4AHn (paper feed n/360 in.)
Auto cutter drive partial cut: 1BH6DH
Code to be sent to the printer
1BH 4AH 96H 1BH 6DH
Macro
$u100=4A1BH
$u101=1B96H
$u102=006DH
OUT_PR $u100 5
* Little endian
When two or more byte data is transferred, it is divided into 1-byte unit. This divided
n=150
Set in the little endian system.
Available command varies depending on the printer model. The V series does
not check the validity of the command before transmitting the command.
Refer to the instruction manual of the printer and set the command correctly.