Hakko Electronics Monitouch V Series, Справочное руководство

Страница: 228 / 746

Chapter 7 Entry Mode
7-37
7
Ite
m S
e
le
c
t Func
ti
on
Item Select Function
•
The cursor can be moved to the specified entry targets only, or it can be
locked to prohibit entry target selection. These operations are set by the
“item select function.”
•
The item select function becomes available when [Data Display] or [Block] is
chosen for [Type], and [Internal] is chosen for [Input Item Select] in the
[Entry] dialog.
•
For using the item select function, set the item select memory ( refer to
page 7-38), or use a switch for which [Item Select] is chosen for [Function] in
the [Switch] dialog (described as follows).
Item Select Switch
When using an item select switch (for which [Item Select] is chosen for
[Function] in the [Switch] dialog), place it over each data display part (entry
target). Pressing the switch moves the cursor to the display part.
Entry Screen
Number 1
Number 2
Number 3
Number 4
Text 1
Max. value
Min. value
Value entered
0
9999
0
0.0
0.00
AAAA
0
0
7 8 9 UP
4 5 6 DW
1 2 3 CLR
0 . +/- ENT
The cursor cannot move to
“Number 2” and “Text 1.”
Item select switches ([Function: Item Select]) must be placed on the editing
layer (base screen or overlaps 0 to 2) for which the [Entry] dialog is set.
Otherwise, the switches do not work.
Number 1
Number 2
Number 3
Number 4
Text 1
Max. value
Max. value
Value entered
0
9999
0
0.0
0.00
AAAA
0
0
7 8 9 UP
4 5 6 DW
1 2 3 CLR
0 . +/- ENT
Switch
Pressing a switch moves the cursor to
the corresponding data display part.