Hakko Electronics FP-948, Инструкция по эксплуатации

Страница: 50 / 68

49
日
本語
中 文
English
6. OPERATION
Controls and displays
Controls
1
1
UP DOWN
2
2
MODEL
FP-948
The front panel of the MODEL FP-948 solder-
ing station has the following controls:
• Four control buttons:
− Initiates a data entry mode.
− End of sequence signal (terminates
a phase of a data entry mode); when
pressed for less than one second,
displays settings already stored.
− Switches the display to IRON 1
• The display for the temperature and the
heat to the IRON 1 will show ON/OFF alter-
nately by pressing more than one second.
• Increases the value in the appropriate
display window.
− Switches the display to IRON 2
• The display for the temperature and the
heat to the IRON 2 will show ON/OFF alter-
nately by pressing more than one second.
• Decreases the value in the appropriate
display window.
●
Operation
1. Turn the power switch ON.
2. Once the temperature is reached, the
buzzer sounds. The heater lamp at the
lower right of the temperature display
starts blinking.
IRON 2
Heater
lamp
IRON 1
Heater
lamp
Display for IRON 1 or 2
CAUTION
The MODEL FP-948 is preset at 350°C at the factory.
Check the temperature setting by pressing the button.
The set temperature will be displayed for two seconds.
CAUTION
Place the iron in the iron holder when not in use.
Displays
The MODEL FP-948 has a three-digit display element.
Depending upon the selected mode, it will display:
• Normal mode:
Sensor temperature (tip temperature)
• Data entry:
Selected quantity (see ʻdata entry proce-
duresʼ for exact characteristics)
• Temperature scale:
°C or °F, depending upon selection
• Error detection:
Refer to ʻERROR MESSAGESʼ section
In addition, heater lamps will flash when the
station has reached the desired temperature,
indicating that it is ready for use.
An audible buzzer is provided to alert the
operator when:
• The station has reached the set tempera-
ture. The buzzer will sound once.
• When the low temperature threshold has been
crossed, the buzzer will sound continuously.
This buzzer will shutoff when the sensed
temperature returns to the acceptable range.
• A failure has occurred in the sensor or
heater (including the sensor circuit), the
buzzer will sound continuously.
• The buzzer will sound once when sleep
function is activated and the tip temperature
starts to decrease.
• When a foreign substance, an incompatible
tip, or the soldering end of the tip is inserted
into the MODEL FM-2025, the display will
blink and the buzzer will sound continuously.
• The auto power shutoff is activated and the
power to the heating element is shutoff, the
buzzer will sound three times.