18
HakkiPilke 50 Easy
Version 1.2 2012
7.
Do the following to ensure that the blade chain lubrication functions automatically: (If necessary, see
Section 5.6.1)
a.
Use the joystick D in Figure 9 to perform a few sawing motions without sawing any actual wood.
b.
Shut down the splitter and disconnect it from its power source.
c.
Open the guard and see if the blade chain has been supplied with oil.
8.
In especially cold weather, the cutting motion can be slow at first. If this is the case, repeat the motion
with the splitting pedal (Figure 9, pedal G), until the oil warms up and the speed returns to normal.
9.
Ensure that pressing the button A of the joystick in Figure 10 releases the wood press and that pressing
the button B of the joystick starts the blade chain.
10.
Start the splitting motion with the splitting pedal (Figure 9, pedal G), and stop it by opening the guard
of the cutting and splitting section.
11.
Ensure that the splitting beam returns to the initial position by holding down the pedal F (Figure 9).
12.
Start the splitting motion by briefly pressing the pedal G (Figure 9).
13.
Test run the input conveyor's feed and return motion with the joystick D in Figure 9.
14.
Test run the lifting motion of the hydraulic wood press by moving the joystick D in Figure 9 forward
and, at the same time, pressing the joystick button A (Figure 10).
15.
Start the output conveyor by using the control H in Figure 9 to adjust the speed to an appropriate
level.
If the machine presents a fault during the test run, determine the reason and take remedial action as
necessary. The machine must be shut down and disconnected from the power source for the duration of the
diagnostics and repairs.
4.2.
Placing wood on a log holder
We recommend auxiliary devices, such as a Woodran 471/Woodran 472 log holder or the hydraulic log hoist
Woodlift 471. If a log holder is not attached to the splitter, the maximum allowed log length is 4.5 m. Always
lift and place wood on the input table in a safe manner that does not endanger the operator.
Note! Placing logs directly on the input table with a loader is strictly prohibited.
Note! Ensure that the log's centre of gravity stays on the conveyor.
4.3.
Feeding and sawing wood
The input conveyor feeds the wood to be processed into the splitter. Push the joystick D in Figure 9 of Section
3.2 to the upper right to feed wood into the machine. The feed can be cancelled by pushing the joystick to the
upper left.
When feeding wood, ensure that the log does not present a risk of getting caught between the log and the
machine, for example due to the shape of the wood. Do not use your hand to guide the log into the cutting
section. Adjust the optical measuring device to the desired measurement and start the output conveyor.
1.
Choose the log to process. Note that the maximum log diameter is 50 cm. The knottiness and shape of
the wood increase the diameter.
2.
Raise the hydraulic wood press by pressing down the button A (Figure 10) of the joystick D (Figure 9)
and by pushing the control lever forwards. Use the joystick D to feed wood into the machine with the
input conveyor. Moving the joystick to the upper right activates the feed. The optical measuring
device stops the conveyor when the desired length has been fed.
3.
When the log stops, lock it in place with the wood press. The wood press is activated automatically
when you lower the cutting flange with the joystick D in Figure 9 (also in Figure 10).
Содержание 50 Easy
Страница 35: ...35 HakkiPilke 50 Easy Version 1 2 2012 13 Electric maps...
Страница 36: ...36 HakkiPilke 50 Easy Version 1 2 2012...
