Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 17 / 38

17
HakkiPilke 50 Easy Version 1.2 2012
2. Turn the dust collector back to the working
position and reattach the cover plate.
4. Remove the dust plate and install the safety
grill as indicated in the figure.
4. Operating the machine
4.1. Test running the machine
The machine must not be used before carrying out a test run and testing all the functions. Both the test run
and testing can only be performed by a person who has studied the machine's manual.
Before the test run, all the components of the log splitter must be checked. If any faults or wear that may
affect the safe use of the machine are discovered, the log splitter must not be used until the faulty or worn
component is replaced and safe use can be ensured.
1. Check that the guard of the log splitter's cutting and splitting section is down.
2. Check that the input and output conveyors are in the operating position.
3. Ensure that the splitting groove is empty.
4. Make sure that you are familiar with the functions of the splitter's controls. If necessary, refer to
Section 3.2.
5. Activation
a. Tractor-powered: Insert the connector of the optical measuring device into the tractor's
electrical socket. Start the tractor and connect the output, starting with a slow speed and
increasing the speed to a maximum of 500 rpm.
b. Electrically-powered: Connect a cable to the log splitter's socket, start the splitter by pressing the
start button and wait a moment. This activates the electric motor at full speed.
6. Start the cutting motion with the joystick D in Figure 9. The cutting motion must be normal when the
blade returns up.