Hakki Pilke 50 Easy, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 11 / 38

11
HakkiPilke 50 Easy Version 1.2 2012
Figure 6. Placing the conveyor in the operating or transport position
Place the output conveyor in the transport position as follows:
1. Use the control H in Figure 9 of Section 3.2 to stop the conveyor.
2. Release the lock D holding the upper section of the conveyor in place, and hydraulically lower
the conveyor to the lowest position with the operating lever E in Figure 9.
3. Position the support bar B over the belt, and fold the upper section of the conveyor onto the
lower section with the handle C.
4. Turn the conveyor to the middle position.
Use the control lever to hydraulically lift the conveyor until it locks into the raised position. Ensure that
the lock A connects firmly.
3.1.3. Placing the working platform in the operating or transport
position
1. Ensure that there is sufficient room for the working platform, and that the ground is
sufficiently even under the legs of the platform.
2. Pull the platform to the working position.
Note! Once the working platform is installed, the splitter can only be transported by means
of three-point attachment.
Figure 7. The working platform in the transport
position
Figure 8. The working platform in the
operating position